One of the most common things we see is drifting controller analogs. A simple replacement will get the controller working properly again, but it doesn’t address the actual issue. Enter Hall Effect analogs. Here you can see a standard analog in a green and blue colour, and the Hall Effect in orange
Removing the potentiometers shows the simple Hall Effect design, a small sensor reads how close the magnet in the module is, as opposed to the connective strips in the standard analog. Even if some dust gets into the Hall Effect module it won’t wear down a delicate connection.
For the replacement, first we open up the controller exposing the board so we can remove the old analogs. Here you can see where we will desolder the old analog pins, and the new hall effect is held just below so you can see where the pins line up…
… and the other side after the installation!
After the installation, the controller is cleaned up and connected to our computer so that the new analogs can be properly calibrated, and finally it’s sent back home, drift free!




